The While test step executes the contained steps repeatedly until the specified condition is TRUE or until a break is encountered.

Drag the While test step from the Test Palette into your test case.

Update the following parameters:

• Condition: The condition to be reached for the test to continue. You can define this using the inbuilt editors
• Counter Name: The name of the loop counter
• Start Value: The starting value of the counter
• End Value: The end value of the counter. Looping will automatically end when this value is passed. If the value is less than the Start Value, then the counter will decrease with each execution instead of increasing.
• Continue on failure: Tick this checkbox if the test should continue after failure.

Then, save the test case.